Midas VeniceU16 Spécifications télécharger pdf (Page 80)

70 Chapter 7: Output Section

VeniceU

Operator Manual

Master outputs sections on the control surface

Item Description

1 stereo to mono switch When this switch is on, a sum of the stereo left

and right signals are routed to the mono signal bus (post-mute and

post-fader, and post-insert points).

2 bal control knob Provides fine adjustment of the left and right power

levels, and can be used during set up to check the left and right channels

separately (by panning fully left or right).

3 MUTE switches and red LEDs These MUTE switches mute the stereo/

mono signals pre-fader. Each red LED illuminates when its mute is on.

4 SOLO switches and yellow LEDs The SOLO switches route the stereo/

mono signal to the PFL mono and AFL stereo buses. The LED for each solo

switch illuminates when its solo is on. Master solo will be overridden by any

other channel/mix solos.

5 Faders These master output faders adjust the output levels, which are

continuously variable from

4 (infinity/off) to +10dB.

6 solo LED This yellow LED illuminates to show when the meters in the

master meters section are functioning as solo meters. The solo bus levels

(afl L, afl R and pfl) are shown on the solo meters. The solo meters are pre-

monitor or phones output mute and level, and are unaffected by changes in

the headphone level or the level sent to the local monitor outputs.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 129 130

Pas de commentaire

Midas VeniceU16 Spécifications Page 80